DALIAN TECH MACHINERY CO.LTD

FOCUS ON YOUR ENTRUST

The high-quality TECHNOBELT (Neoprene and Polyurethane Belt) has won high praise from many famous original equipment manufacturers and maintenance companies all over the world.

View details

FOCUS ON YOUR ENTRUST

The high-quality TECHNOBELT (Neoprene and Polyurethane Belt) has won high praise from many famous original equipment manufacturers and maintenance companies all over the world.

View details

Products information

News Center

Home page

The Failure and Treatment Method of Single-tooth Timing Belt

The failure of single tooth Timing Belt:

1. The belt body of the single tooth Timing Belt is broken due to fatigue.

2. The teeth of the Timing Belt are sheared and crushed.

3. The belt teeth of the single-tooth Timing Belt also have the phenomenon of wear and peeling of the foreskin on the belt side.

4. If the bearing surface of the timing belt is stretched and the pitch becomes larger, the teeth of the timing belt will crawl.

5. Due to excessive impact and overload, the belt body of the single-tooth synchronous belt is broken.

6. The back of the belt body of the single tooth synchronous belt has cracks or the belt body becomes soft.

7. The belt body of the single tooth synchronous belt becomes louder during operation.

Treatment method for failure of single tooth Timing Belt:

1. Check the type of the synchronous belt before installation, and replace it if necessary.

2. If it is not possible to twist the timing belt, when installing a wider timing belt or a larger timing belt, the diameter of the timing belt needs to be increased or the timing belt needs to be widened, and the sundries must be removed during installation and Tension.

3. If the single-tooth timing belt is out of alignment, you need to adjust the bearing immediately, and then replace the flange of the timing belt wheel, and you need to reinforce the bearing or chassis.

4. When the timing belt is longitudinally cracked, it is necessary to replace the flange of the timing pulley immediately, and then realign the bearing of the timing pulley, and increase the tension appropriately, and need to remove foreign objects, install the protective cover correctly, and check it. The cutting device also has the guiding device of the synchronous pulley.