DALIAN TECH MACHINERY CO.LTD

FOCUS ON YOUR ENTRUST

The high-quality TECHNOBELT (Neoprene and Polyurethane Belt) has won high praise from many famous original equipment manufacturers and maintenance companies all over the world.

View details

FOCUS ON YOUR ENTRUST

The high-quality TECHNOBELT (Neoprene and Polyurethane Belt) has won high praise from many famous original equipment manufacturers and maintenance companies all over the world.

View details

Products information

News Center

Home page

How to Distinguish the Quality of Rubber Conveyor Belts

Rubber Conveyor Belts are widely used due to their heat resistance, acid and alkali resistance. As an important part of the conveyor, the quality of the Rubber Conveyor Belt not only affects the efficiency of the conveyor, but also has an important impact on the use of the conveyor. Therefore, the choice of Rubber Conveyor Belt can’t be careless.

1. First look at the surface of the Rubber Conveyor Belt. The rubber surface of a good belt should be smooth and flat, free of bubbles, grooves, and dry scars.

2. Shiatsu method: pinch the rubber surface with your nails. The Rubber Conveyor Belt with high gel content will not be pinched off or broken. The pinch marks will recover in 3-5 seconds. The lower the gel content, the slower the recovery. Does not recover.

3. Odor method: The Rubber Conveyor Belt with high content of rubber has no nasal and light smell, and the rubber conveyor with high reclaimed rubber has a very nasty smell.

4. Look at the belt core: high-quality Rubber Conveyor Belts have the same layer core and uniform thickness of glue; inferior conveyor belts will have different thicknesses.

When the Rubber Conveyor Belt is running normally, the belt speed is not less than 95% of the roller speed. If the friction between the roller and the conveyor belt is not enough, the conveyor belt is prone to slipping. There are many reasons for the insufficient friction between the roller and the conveyor belt, the common ones are: insufficient tension, load start, insufficient friction coefficient of the roller surface, etc. The reasons for insufficient tension are: insufficient tensioning stroke, insufficient counterweight, too long conveyor belt, etc.; reasons for insufficient friction coefficient of the roller surface: too much rubber wear on the roller surface, excessive wetness of the belt body, or lubricating oil , There are materials on the surface of the belt body (easy to be swelled by water).